3 4 6 Lab Lab 3 4 Lab Configure Vlans And Trunking Part 1 Step 4 Questions Can Pc A

By switzerlandersing On Sep 13, 2025

Lab 3.1 (3.4.6) - Configure VLANs And Trunking | PDF

Lab 3.1 (3.4.6) - Configure VLANs And Trunking | PDF Audio tracks for some languages were automatically generated. learn more. Refer to the router interface summary table at the end of the lab for the correct interface identifiers. note: ensure that the routers and switches have been erased and have no startup.

Hands-on Lab: VLANs And Trunking Configuration | Course Hero

Hands-on Lab: VLANs And Trunking Configuration | Course Hero In general, vlans make it easier to design a network to support the goals of an organization. vlan trunks are used to span vlans across multiple devices. trunks allow the traffic from multiple vlans to travel over a single link, while keeping the vlan identification and segmentation intact. In part 4, you will configure interface f0/1 to use the dynamic trunking protocol (dtp) to allow it to negotiate the trunk mode. after this has been accomplished and verified, you will disable dtp on interface f0/1 and manually configure it as a trunk. In part 4, you will configure interface f0/1 to use the dynamic trunking protocol (dtp) to allow it to negotiate the trunk mode. after this has been accomplished and verified, you will disable dtp on interface f0/1 and manually configure it as a trunk. This document describes a lab to configure vlans and trunking between two switches.

Lab 6: Configure VLANs, Trunking & Network Connectivity | Course Hero

Lab 6: Configure VLANs, Trunking & Network Connectivity | Course Hero In part 4, you will configure interface f0/1 to use the dynamic trunking protocol (dtp) to allow it to negotiate the trunk mode. after this has been accomplished and verified, you will disable dtp on interface f0/1 and manually configure it as a trunk. This document describes a lab to configure vlans and trunking between two switches. In this packet tracer physical mode (ptpm) activity, you will create vlans on both switches in the topology, assign vlans to switch access ports, and verify that vlans are working as expected. In part 1, you will set up the network topology and configure basic settings on the pc hosts and switches. step 1: cable the network as shown in the topology. attach the devices as shown in the topology diagram, and cable as necessary. step 2: configure basic settings for each switch. a. console into the switch and enable privileged exec mode. b. Vlan trunks are used to span vlans across multiple devices. trunks allow the traffic from multiple vlans to travel over a single link, while keeping the vlan identification and segmentation intact.